Our innovative team of engineers have the extensive knowledge required to design and build impressive specialty equipment for any industry. Customers come to us with ideas when they’re not sure where to turn, and we get to work on bringing their ideas to life. No idea is too outrageous, and we are always up for an exciting challenge.
Our highly skilled service technicians offer both in-house and on-site training and support internationally.
The Pre-Heating Oven does just that: it pre-heats aluminum sheets to 1000 deg. F in 90 seconds for easy manipulation to automotive forming. Designed for minimum heat loss for energy efficiency, our standard 2m x 4m oven comes with Allen Bradley CompactLogix PLC controls, Allen Bradley HMI Panelview Plus 1000, 16 zone temperature control, a 24” opening, and hydraulic closing. Alternative selections include:
- Custom sheet sizes
- Specialty platen materials
- Higher temperatures
- Increased/Decreased opening sizes
- Ejector Pins (mechanical or hydraulic actuation)
What better way to manage your silicone than to stuff it! Reduce loss of material and increase efficiency with the silicone stuffer designed to continuously feed silicone directly into your press rather than manual input. Designed for easy hook-up to any press (including the Sherdil Precision Rubber Injection Press), the silicone stuffer is equipped with a state of the art hydraulic power unit, PLC controls, and optional vacuum pump for air suction.
Two models available:
2L Mark 3e
- 105” high x 60” wide x 80” deep
- (2) 11.25” barrels, 1,800 cu. in. capacity each
- Feed rate from 2oz/min to 5lbs/min
100L Mark 2
- 66” high x 54” wide x 28” deep
- (2) 16” barrels, 3,000 cu. in. capacity each
- Feed rate from 5lbs/min and up